Filter
Top Products
41
Section 5: Maintenance & Lubrication
11/11/12
RCB6610 & RCBM6610 Series 2 S/N 944730+ Rotary Cutters 330-584M
Table of Contents
Center Skid Shoe
Figure 5-1
Wing Skid Shoe
Figure 5-2
Side Skirt Maintenance
Figure 5-3
Item Part No. Description
1 330-185H CENTER SKID SHOE
30280
37641
Item Part No. Description
1 330-835D WING SKID SHOE
2 331-120H HARDENED WING SKID SHOE
3 802-466C PLOW BOLT, 3/8" - 16 x 1 1/4" grade 5
Item Part No. Description
1 See Parts Manual for Part Numbers and color options.
37642
Weight Box Skid Shoe
Figure 5-4
Weight Box Skid Shoe
Refer to Figure 5-4:
Reverse or replace weight box skid shoe as follows:
1. Remove 3/8" hex whiz nuts (#3), 3/8"-16 GR5 plow
bolts (#2), and weight box skid shoe (#1) as shown.
2. Plow bolts (#2) should be checked for wear and
replaced if necessary.
3. Reverse existing skid shoe and reattach or attach
new skid shoe (#1) to cutter with 3/8" plow bolts (#2)
and secure with 3/8" hex whiz nuts. Tighten whiz nuts
to the correct torque.
Gearbox Shaft Guard
Figure 5-5
Gearbox Shaft Guard
Refer to Figure 5-5:
1. To remove shaft guard (#1) at the spindle gearbox
and splitter gearbox, unsnap latches (#2) on both
sides of guard (#1) and slide guard over driveline to
expose driveline yoke and yoke grease zerk. Do not
unhook safety chain (#3).
2. When servicing of driveline yoke is completed, return
shaft guard to its original position and secure with
latches (#2).
3. Check safety chain (#3). Make sure it is latched to
shaft guard mounting plate (#4) and shaft guard (#1).
27588
Skid Shoe is
Reversible
Item Part No. Description
1 318-923D WEIGHT BOX SKID SHOE
2 802-466C PLOW BOLT, 3/8" - 16 x 1 1/4" grade 5
37618