Filter
Top Products
38
Section 4: Options & Accessories
RCB6610 & RCBM6610 Series 2 S/N 944730+ Rotary Cutters 330-584M
11/11/12
Table of Contents
Mechanical Winch Installation
Figure 4-3
30237
Cable Hook
Hydraulic Hose Fitting
on Piston Side
Wrap Cable Around
Base of Gearbox and
Clip Hook Back to Cable
Operating Instructions
!
DANGER
Make sure no one is in the area where the deck will be raised.
The cable could come loose or break and drop the wing
suddenly causing serious bodily injury or death.
1. Pull cable hook with cable out pass the gearbox.
2. Attach cable to wing deck by routing cable around the
gearbox base and clipping cable hook back to the
cable or by hooking the cable to the wing deck side
panel. Make sure the cable is secured and will not
slip or come loose before raising the deck up.
3. Turn mechanical winch handle to raise deck. If
cylinder rod will not retract while raising the wing up,
loosen hydraulic hose fitting on the piston side of the
cylinder to allow pressure to bleed off while raising
the wing up.
4. Secure wing deck in the raised position with the
cylinder transport lock. See “Transport Lock”
instructions on page 32.
5. Unhook cable and reel cable up with the hand crank.
IMPORTANT: If wing driveline profile is bent or
twisted, disconnect that driveline from the wing
gearbox before folding the wing up. This will protect
both the wing and divider gearbox. Repair driveline
before putting cutter back into service.
Mechanical Wing Lift
330-414A RC56 Mechanical Winch Kit
Refer to Figure 4-3:
An optional mechanical winch kit is available for raising
the wing to transport position when the hydraulic system
is not working or when the towing vehicle is not equipped
with the proper hydraulic connections.
Installation Instructions
1. Attach winch mounting frame (#1) to the center deck
as shown with 5/8"-11 x 2 3/4" GR5 cap screws (#2),
flat washers (#4), and hex flange lock nuts (#3).
Tighten nuts to the correct torque.
NOTE: Tool Box and Mechanical Winch use the
same mount. Therefore, only one can be selected.