Filter
Top Products
5 - Front Panel Operation
70
Action Display
1.
Displays the minimum current
Displays the rms voltage
Displays the input power
Displays the maximum power
Displays the minimum power
Use and to scroll through the measurement selections
<chan> <value> A MIN
<chan> <value> A RMS
<chan> <value> WATTS
<chan> <value> W MAX
<chan> <value> W MIN
7 - Setting the GPIB Address
Your electronic load is shipped with the GPIB address set to 5. This address can only be changed from the front
panel using the Address menu located under the Address key
Set the GPIB address as follows:
Action Display
1.
On the System keypad, press Address.
ADDRESS 5
2. Enter the new address. For example, Press 7, Enter. ADDRESS 7
8 - Storing and Recalling Instrument States
You can save up to 10 states (from location 0 to location 9) in non-volatile memory and recall them from the
front panel. All programmable settings are saved.
NOTE: The SAV0 state is the power up state.
Save an instrument state in location 0 as follows:
Action Display
1. Set the instrument to the state that you want to save.
2. Save this state to location 0. Press Shift, Save, 0, Enter. *SAV 0
Recall a saved state as follows:
Action Display
1.
Recall the state saved in location 0 by pressing Recall, 0, Enter.
*RCL 0
Clear the non-volatile memory of the electronic load as follows:
Action Display
1. On the System keypad, press the Recall key and scroll to the reset command. Then
press Enter.
This returns the unit to the factory-default settings.
*RST
2. Save these settings to location 0. Press Shift, Save, 0, Enter. *SAV 0
3. Repeat step #2 for memory locations 7 through 9. *SAV 7
*SAV 8
*SAV 9
•
‚