Filter
Top Products
3 - Installation
42
Input Connections
Power Cord
1. Connect the power cord to the IEC 320 connector on the rear of the unit. If the wrong power cord was
shipped with your unit, contact your nearest Agilent Sales and Support Office (refer to the list at the back of
this guide) to obtain the correct cord. See Figure 3-5 for the part number and ordering options.
Figure 3-5. Power Cord Configurations
Manually-Tightened Connectors
The standard manually-tightened input connectors are located on the rear panel and are used for connecting
unterminated wires directly to the back of the modules.
Two screw-down connectors (+ and -) are provided on each module for connecting the input wires to the
electronic load (see figure 3-6a). Connections are made as follows: