64 Start Menu Program Options
MX3-CE Reference Guide E-EQ-MX3CERG-G-ARC
Site Survey Tool
Immediately runs signal strength and quality and link speed. An option is available to Setup
parameters for Active Mode reporting.
Wireless Login Module
LEAP must be enabled before this option can be edited or viewed.
Communications
Note: Some communication menu options require an external modem connection to the MX3-
CE. Modems are not available from LXE nor supported by LXE.
ActiveSync
Once a relationship has been established with Connect, ActiveSync will synchronize using the
radio link, serial ports, or the infrared port on the MX3-CE.
Note: ActiveSync does not transmit through the IR port in cradles.
Connect
Connect is used to initiate a hardwired connection to a host. Several pre-defined connect setups
are included in the factory setup:
• COM1 direct connect at 57600 or 115200 baud
• Infrared connect at 57600 or 115200 baud
• COM3 direct connect at 57600 or 115200 baud
• USB direct connect
The default connect setup is COM1 at 57600 baud.
After a connect setup is selected, Start | Communications | Connect will start to connect to a
host. After this connection is made and an ActiveSync relationship established, the ActiveSync
menu item can be used to establish the connection over the radio link.
Select "Make New Connection" and follow the instructions on the screen to create a connection
while following the directions in the section titled "Backup MX3-CE Files" later in this chapter.
Remote Networking
Remote networking is used to create a connection with a different baud rate than the default baud
rate. The connections are then displayed in the PC Connection tab of the Communications control
panel.
Select "Make New Connection" and follow the instructions on the screen to create a new
connection.
