Getting Started 5
E-EQ-MX3CERG-G-ARC MX3-CE Reference Guide
Getting Started
Note: When your MX3-CE is pre-configured, the radio, PCMCIA card and endcaps are
assembled by LXE to your specifications.
This section’s instructions are based on the assumption that your new system is pre-configured
and requires only accessory installation (e.g. handstrap, stylus) and a power source. LXE
recommends that installation or removal of accessories be performed on a clean, well-lit surface.
When necessary, protect the work surface, MX3-CE, and components from electrostatic
discharge.
Figure 1-4 Hardware Configuration
Use this guide as you would any other source book -- reading portions to learn about the MX3-
CE, and then referring to it when you need more information about a particular subject. This guide
takes you through an introduction to and operation of the LXE MX3-CE.
In general, the sequence of events is:
1. Insert a fully charged battery and press the Power button.
2. Connect an external power source to the unit (if required).
3. Adjust screen display, audio volume and other parameters if desired.
Note: New batteries must be fully charged prior to use. This process takes up to four hours in
an LXE Multi-Charger and up to eight hours using the MX3-CE internal charger.
Troubleshooting
Can’t align the screen, change the
date/time or adjust the volume.
AppLock is installed and running on the mobile device.
AppLock restricts access to the control panels. Contact
your System Administrator. See Also: “AppLock”.
