LXE MX3-CE Manual

A SERVICE OF

next previous

4 Quick Start

MX3-CE Installation and Operator’s Guide E-EQ-MX3CEOGWW-A-ARC

Quick Start

Figure 3 Hardware Configuration

This section's instructions are based on the assumption that your new system is pre-configured and

requires only accessory installation (e.g. hand strap, external barcode scanner) and a power source.

Use this guide as you would any other source book -- reading portions to learn about the MX3-CE,

and then referring to it when you need more information about a particular subject. This guide

takes you through an introduction to and operation of the LXE MX3-CE.

In general, the sequence of events is:

1. Insert a fully charged battery.

2. Connect an external power source to the unit (if required).

3. If the screen does not automatically display, tap the Power button.

4. Adjust screen display, audio volume and other parameters if desired.