142 Appendix D Barcodes
MX3-CE Reference Guide E-EQ-MX3CERG-G-ARC
Aim Duration
Note: For correct operation, reboot the mobile device after changing this value.
When a scanner with an aim mode
5
is triggered either by a trigger pull, or a Start_Decode
command, this parameter sets the duration the aiming pattern is seen before a scan attempt begins.
It does not apply to the aim signal or the Aim_On command. It is programmable in 0.1 second
increments from 0.0 to 9.9 seconds. No aim pattern is visible when the value is 0.0.
To set aim duration, scan the barcode below:
im Duration
Next scan two numeric barcodes that correspond to the desired aim duration. Times less than 1.0
second must have a leading zero. For example, to sent an aim duration of 0.5 seconds, scan the
barcode below, then scan the “0” and “5” barcodes. If you make an error, or wish to change your
selection, scan the Cancel barcode.
5
SE1200LR and SE1200HV scan engines have aiming patterns, other types of SE1200 scan
engines do not have aiming patterns.
