A SERVICE OF

logo

180 Appendix D Barcodes
MX3-CE Reference Guide E-EQ-MX3CERG-G-ARC
Transmit Code 39 Check Digit
Parameter Default Value: Disable
When enabled, the check digit is transmitted with the data.
Parameter setting for “Code 39 Check Digit Verification” has no effect on this parameter value.
Set this parameter by scanning either of the barcodes shown below.
Enable
Transmit C39 Check Di
g
Disable
Do not Trans C39 Chk
D
Trioptic Code 39
Parameter Default Value: Disable
Trioptic Code 39 symbols always contain six characters.
When Trioptic Code 39 is enabled, set the “Code 39 Full ASCII” parameter to disabled. Both
parameters should not be enabled simultaneously.
Set this parameter by scanning either of the barcodes shown below.
Enable
Enable Trioptic Code 3
9
Disable
Disable Trioptic Code 3
9