164 Appendix D Barcodes
MX3-CE Reference Guide E-EQ-MX3CERG-G-ARC
Stop Bit Select
Parity Parameter Default Value 1
The stop bit(s) at the end of each transmitted character marks the end of transmission of one
character and prepares the receiving device for the next character in the serial data stream.
The number of stop bits selected (one or two) depends on the number the receiving computer is
programmed to accommodate. Set the number of stop bits to match host device requirements.
Set this parameter by scanning one of the following barcodes.
One Stop Bit
1 Stop Bit
Two Stop Bits
2 Stop Bits
Time-out Between Decodes, Same Symbol
Parameter Default Value: 1.0 second
Use this parameter to prevent the beeper from continuously beeping when a symbol is left in the
scanner's field of view.
To begin setting differing symbol timeout values, scan this barcode:
Timeout / Decodes - Sam
Using the "Keypad Number Symbols" section at the end of this chapter, scan two numeric
barcodes that represent the desired interval, in 0.1 second increments. Valid values are between
0.0 and 9.9 seconds. Single digit values must be predefined by a leading zero. For example, to set
a timout of 0.5 seconds, scan the Timeout/Decodes – Same barcode, then scan the number 0 and 5
barcodes.
If you wish to change your number selection, scan Cancel on the “Keypad Number Symbols”
page.
