A SERVICE OF

logo

Appendix D Barcodes 153
E-EQ-MX3CERG-G-ARC MX3-CE Reference Guide
Linear Security
Level 4 All code types (Code 128 exception) must be successfully read three
times before being decoded.
Linear Security Level 4
Cancel
Note: Parameter does not apply to Code 128 for the SE923.
Parameter Scanning
Parameter Default Value: Enable
Use this parameter to decide whether scanner parameters can be set using the barcodes in this
chapter.
Note: When this parameter is disabled, scan the Set Defaults parameter barcode to enable
parameter scanning.
When disabled, either scan the Enable Parameter Scanning barcode or the Set All Defaults
barcode (or set this parameter to 01h via a serial command) to reset the parameter and barcodes in
this chapter can then be scanned.
When enabled, scanners can be configured using the barcodes in this chapter.
Select a mode by scanning either of the barcodes shown below.
Enable
Enable Parameter Scan
Disable
Disable Parameter Sca
n