Configuration Menu Settings
2-16 Control Panel
Imageshift.top
-720(min)
= 0
720(max)
This setting allows you to incrementally adjust the top position
of the image on paper in units, an incremental adjustment. The
factory default unit scale is 1/720", but you can reset the unit
size with the unit setting (see “Unit” on page 2-17). A typical
situation is alignment of text to a pre-printed form. You can
adjust within a range of 1 inch positive and 1 inch negative, in
1/720" increments, as listed below.
Imageshift.left
-720(min)
= 0
720(max)
This setting allows you to incrementally adjust the left position
of the image on paper in units, an incremental adjustment. The
factory default unit scale is 1/720", but you can reset the unit
size with the unit setting (see “Unit” on page 2-17). A typical
situation is alignment of text to a pre-printed form. You can
adjust within a range of 1 inch positive and 1 inch negative, in
1/720" increments, as listed below.
inch
milli
meter
Unit Size Setting Range
1/100" 1/200" 1/300" 1/600" 1/720" mm
Minimum -1 -25.4 -100 -200 -300 -600 -720 -25
Maximum +1 +25.4 +100 +200 +300 +600 +720 +25
Customsize.width
2837(min)
= 8417
8417(max)
This setting configures the media size of nonstandard media. It
is only used when you have a custom paper tray and one of the
PapSize values is set to Cus(custom). The table below lists the
minimum and maximum custom paper widths in units, an
incremental adjustment. The factory default unit scale is 1/720",
but you can reset the unit size with the unit setting (see “Unit” on
page 2-17).
customsize.width inch
milli
meter
Unit Size Setting Range
1/100" 1/200" 1/300" 1/600" 1/720" mm
Minimum 4.72 120 394 788 1182 2364 2837 120
Maximum 11.69 297 1169 2338 3507 7014 8417 297
