Printer Pick Roller Kit - Replacing the Tray Pick Rollers
Ordering and Replacing Consumables 4-33
Consumables
Printer Pick Roller Kit - Replacing the Tray Pick Rollers
Replace the pick rollers whenever the Control Panel indicates:
Pick Roller At End Life
Replace Pick Roller
or when you get excessive pick errors.
Each tray and the HCI contain pick rollers. The Control Panel will indicate which one requires
replacement. This procedure is applicable to all three printer trays (tray1, tray2, and tray3). For
the HCI replacement procedures, see “HCI Pick Roller Kit - Replacing the HCI Pick Rollers”
on page 4-42.
At the Control Panel
1. Press the Menu button on the Main Screen.
2. Press
Ĭ to select Maintenance.
3. Press
Ǡ to select Maintenance options.replace should be highlighted.
4. Press Select to enter the replace submenu.
5. Press
Ĭ to select the set of tray rollers to be replaced.
6. Press Select.
Removing the Printer Pick Rollers (Upper and Lower)
1. To reach the tray pick rollers more easily, remove all three trays from the printer and set
them aside, as shown in Figure 4-38 below.
Figure 4-38 Removing Paper Trays - all trays removed
Tray3
Tray1
Tray2
Pick rollers
Pick rollers
Pick rollers
