A SERVICE OF

logo

Open as PDF
next previous
HCI Pick Roller Kit - Replacing the HCI Pick Rollers
Ordering and Replacing Consumables 4-49
Consumables
Installing the HCI Lower Pick Rollers
1. Hold the lower roller assembly and slide the front (closest) shaft into the front metal
retaining clip. Slide the back shaft into the back retaining clip. See Figure 4-68.
Figure 4-68 Installing Lower Roller Assembly
2. Snap the white plastic clip into place. It fits over a groove on the back end of the shaft to
secure the lower rollers (See Figure 4-69.) If you don’t see this groove, the rollers may
not be completely seated all the way onto the shaft.
Figure 4-69 Installing Clip onto Lower Roller Assembly