Drum Kit - Replacing Drum and Transfer Assembly
4-18 Ordering and Replacing Consumables
Drum Kit - Replacing Drum and Transfer Assembly
The drum and transfer charger are always replaced together. The drum is replaced when the
Control Panel indicates:
Drum at end life
Replace drum
Caution The drum surface is easily damaged. Avoid contact with the drum surface and
don’t expose the drum to light for extended periods of time. Scratches will appear as dark lines
or marks on the printed page. A scratched drum should be replaced.
This section provides maintenance procedures for:
• Removing the old transfer assembly and installing the new transfer assembly (See
“Removing the Transfer Assembly” on page 4-19).
• Removing the old drum and installing the new drum (See “Installing the Drum” on
page 4-24).
Setting Up the Printer for Drum Kit Replacement
1. Press the Menu button on the Main Screen.
2. Press
Ĭ to highlight Maintenance.
3. Press
Ǡ to display Maintenance selections.
4. Press
Ǡ to enter the Replace submenu.
5. Press
Ĭ to highlight DRUM UNIT.
6. Press
Ǡ to display drum instructions as shown in Figure 4-22.
Figure 4-22 Replace Drum
Online
Drum Replacement
Replace Drum unit
and Press Done
Done
