Filter
Top Products
21. Rotate spool and sleeve assembly until pin is paral-
lel with port face. Install drive, make sure you engage
drive with pin, To assure proper alignment, mark drive
as shown in Fig. 65 (ref. B). Note relationship between
slotted end of drive to splined end of drive when mark-
ing.
22. Install 3" diameter seal in meter.
23. With seal side of meter toward spacer plate, align
star valleys (ref. A) on drive (ref. B). Note the parallel
relationship of reference lines A, B, C, and D. Align bolt
holes without disengaging meter from drive.
Figure 63
Figure 64
Figure 65
Repairs Page 4 - 70 Greensmaster
®
3100