Filter
Top Products
17. Push spool partially from control end of sleeve, then
remove 6 centering springs from spool carefully by hand
18. Push spool back through and out of sleeve. Rotate
spool slowly when removing from sleeve.
19. Remove seal from housing.
20. Remove set screw from housing.
21. Screw a #10-24 machine screw into end of check
ball seat. Then by pulling on screw, with a pliers, lift seat
out of housing.
22. Remove two (2) seals from check valve seat.
23. Tip housing to remove check ball and check ball
retainer.
Figure 52
Figure 53
Greensmaster
®
3100 Page 4 - 65 Repairs