Filter
Top Products
Greensmaster 3100
Dual Point Adjust Cutting units
Page 10 - 3
Special Tools
OTC (Owatonna Tool Company) supplies special tools
for servicing Toro Commercial Products. The TORO
SPECIAL TOOLS AND APPLICATIONS GUIDE shows
service tool applications.
Some tools may have been supplied with your mower or
available as TORO parts. Some tools may also be avail-
able from a local supplier.
Gauge Bar Assembly
Used to verify height–of–cut.
Toro Model Number: 13–8199
Figure 2
Backlapping Brush Assembly
Used to apply lapping compound to cutting units while
keeping the operator’s hands at a safe distance from the
rotating reel.
Toro Model Number: TOR299100
Figure 3
Bedknife Screw Tool
This screwdriver–type bit is made to fit Toro bedknife at-
taching screws. Use this bit with a torque wrench to se-
cure the bedknife to the bedbar.
IMPORTANT: DO NOT use and air or manual impact
wrench with this tool so damage to the bedbar will
be prevented.
Toro Model Number: TOR510880
Figure 4
Rev. D