Filter
Top Products
Maintenance
TDS3000 Series Service Manual
6–17
Installation. Use this procedure to install the fan, line filter, parallel printer port
cable, external power jack, power supply, battery board, and rear chassis. Skip
the steps for modules that are already installed.
Bend the tabs
External power cable
Rear chassis
Fan cable
hole
Label
Key on
Power jack
Figure 6–8: Installing the fan, line filter, and line power cable
1. Insert the fan cable through the hole in the rear chassis and place the fan in
its cavity. The fan label should face toward the rear chassis. See Figure 6–9.