Filter
Top Products
Operating Information
2–8
TDS3000 Series Service Manual
6. If the application module came with one or more floppy disks, insert the
firmware upgrade floppy disk into the disk drive. If there is more than one
floppy disk, insert firmware upgrade floppy disk number one into the disk
drive.
7. Power on the oscilloscope. The oscilloscope determines whether the
firmware update is necessary. If no firmware update is necessary, the
oscilloscope powers on with no messages. Go to step 9.
8. Push OK Load New Firmware to begin loading the firmware. During the
process, the oscilloscope may instruct you to insert a second floppy disk;
insert the second firmware disk at that time. When the firmware upgrade is
complete, the oscilloscope will restart automatically with the new firmware.
NOTE. If you power off the oscilloscope, eject a floppy disk, or there is a power
outage during the upgrade process, you must power off the oscilloscope and do
the firmware upgrade procedure, starting at step 6, before you can use the
oscilloscope.
9. Remove the floppy disk.