Filter
Top Products
OPERATION
OPERATION
Operation Section 4-13
© 2004 Alamo Group Inc.
SR10M/SR15M 10-01
LEVELING DECK CENTER SECTION
1. Place the tractor and mower on a level surface
and lower both wings.
2. Using the center section hydraulic cylinder,
position the mower so the skid shoes are 1” less
off the ground than the desired final cut height.
For example, for a 3” cut raise or lower the mower
until the skid shoes are approximately 2” off the
ground..
3. Shut down the tractor, place the transmission in
park, and set the parking brake before
dismounting.
4. Level the mower deck front to rear by adjusting
the leveling rods linking the tongue to the rear
axle. DO NOT allow feet or other body part
underneath the mower when making adjustments.
To adjust rod length, loosen jamnut and screw
turnbuckles. To lower the front, lengthen the rods
and to raise the front, shorten the rods. DO NOT
unscrew turnbuckles to the point that either rod
threaded ends becomes disconnected which will
cause the mower to fall. Re-tighten jamnuts when
deck is leveled.
IMPORTANT: Alternate adjustments between
rods and adjust at equal lengths to maintain equal
tension. Improper adjustments may cause rods
to snap or bend.
5. Place split collar assemblies on the center axle
hydraulic cylinder rod to maintain a set cutting
height each time the mower is raised and lowered.
6.1 SETTING DECK HEIGHT
6. SETTING THE MOWER
Properly setting the cutting height is essential for efficient and safe operation. A properly set mower will make
a more uniform cut, distribute clippings more evenly, require minimal tractor work, and follow the contour of
uneven terrain. Note: Avoid very low cutting heights, striking the ground with the blades gives the most damaging
shock loads and will cause damage to the mower and drive. Blades contacting the ground may cause objects
to be thrown out from under the mower deck. Always avoid operating the mower at a height which causes the
blades to contact the ground.
Never work under the Implement, the framework, or any lifted compo-
nent unless the Implement is securely supported or blocked up to
prevent sudden or inadvertent falling which could cause serious injury
or even death. (SG-14)
DANGER!
Leveling Rod Adjustments
Split Collar Assemblies
Leveling Rod Adjustments