Filter
Top Products
ASSEMBLY
Assembly Section 3-11
© 2004 Alamo Group Inc.
SR10M/SR15M 10-01
ASSEMBLY
DRIVELINE ATTACHMENT
Remove Divider Gearbox Shield if installed. Remove any tape from Gearbox shafts. Attach the Slipclutch end
of the Wing Driveline to the Divider Gearbox. Attach the clamp collar end of Driveline to Wing Gearbox. Tighten
bolts evenly to their proper torque. FIGURE 16 & FIGURE 17. Install the Main Driveline with clamp collar to the
Divider Gearbox .
FIGURE 16. Wing Driveline Clutch End Attachment
FIGURE 17. Wing Driveline Clamp Collar End Attachment
NOTE: Divider Gearbox Shield must be
in place to guard connecting yokes and
clutches.
WING DRIVELINE
SLIP CLUTCH END
MAIN DRIVELINE
DIVIDER GEARBOX
NOTE: Wing Gearbox Shield must
be in place and lowered to guard
connecting yokes and clutches.
WING DRIVELINE
CLAMP COLLAR END