Filter
Top Products
OPERATION
OPERATION
Operation Section 4-11
© 2004 Alamo Group Inc.
SR10M/SR15M 10-01
1. Ensure the tractor is equipped with the correct
PTO shaft and the drawbar is set at the correct
length.
2. Using the parking jack, position the tongue clevis
to the height of the tractor drawbar. Adjust the
mower tongue to be level and parallel with the
tractor drawbar using the control rod connecting
the mower tongue to the deck.
3. Board the tractor and start the engine. Back the
tractor to the mower aligning the drawbar hitch
hole with the mower tongue clevis. Turn off the
tractor engine, place the tractor in park, and set
the parking brake before dismounting.
4. To attach the mower, place two 1” flatwashers
positioned under top lip of tongue clevis and to
the top of drawbar. Add additional 1” flatwashers
between the bottom of drawbar and bottom lip of
clevis to fill open space. Insert a 1” diameter grade
5 or 8 bolt through clevis and drawbar and retain
in position with a 1” locknut. Tighten the locknut
securely but do overtighten which could spring or
break the clevis. NEVER attach the mower to the
tractor with a pin not having a nut.
5. Securely attach the mower safety chain to the
tractor drawbar or drawbar support frame.
6. Lower the jack until the tongue is completely
supported by the drawbar. Remove jack from the
tongue and place on storage bracket of mower.
5.1 Connecting the Mower Tongue to the Tractor
Parking
Jack
TongueClevis
Drawbar
Safety Tow Chain
If the mower is towed on a public roadway, a safety chain with tensile strength equal to or greater than the gross
weight of the mower must be connected between the tractor and mower. This will help control the implement in
the event the tongue becomes disconnected from the drawbar. After connecting both ends of the safety chain,
drive the tractor to the right and left to check for proper chain length. Adjust length as necessary and allow only
enough slack in the chain to make a maximum turn in both directions.
5. CONNECTING THE MOWER TO THE TRACTOR
Use extreme caution when connecting the mower to the tractor. The mower should be securely resting at
ground level or on blocks. Place a block in front of and behind the center section wheels to prevent the mower
from moving. Keep hands and feet out from under the mower and clear of pinch points between the tractor and
mower.
DANGER!
Always shut the Tractor completely down, place the transmission in park, and set the
parking brake before you or anyone else attempts to connect or disconnect the Implement
and Tractor hitches. (S3PT-15)
Positioning
Nut