Filter
Top Products
OPERATION
Operation Section 4-26
OPERATION
© 2004 Alamo Group Inc.
SR10M/SR15M 10-01
9.5 Crossing Ditches and Steep Inclines
When crossing ditches with steep banks or going up
sharp inclines, it is possible that the main driveline
inner profile will penetrate into the outer housing to its
maximum depth until the assembly becomes solid
(driveline is at its extreme shortest length). This type
of abusive operation can cause serious damage to
the tractor and mower drive by pushing the PTO into
the tractor and through the support bearings or
downward onto the PTO shaft, breaking it off.
Damage resulting from over-collapse of the driveline’s inner profile and its outer housing
may allow the driveline to come loose from the Tractor which could cause bodily injury to
the operator or bystanders and/or extensive damage to the Tractor or Implement
WARNING!
When confronted with an incline or ditch, do not
approach from an angle which is perpendicular or
straight on as damage to over collapse of the driveline
may occur.
When crossing such terrain, the wings should be fully
lowered for a lower center of gravity and added
stability.
Inclines and ditches should be approached along a
line which is at an angle as shown. This type of path
will reduce the possibility of over-collapse of the
driveline and resulting damage. If the gradient is so
steep that such as approach increases the possibility
of a tractor roll-over, select an alternate crossing path.
CORRECT: Approach ditch at an angle
INCORRECT: DO NOT approach ditch straight on.
When operating the tractor and mower across slopes and inclines, through ditches, and other uneven terrain
conditions, it is important to maintain sufficient deck to ground clearance. Blade contact with the ground may
cause soil, rocks and other debris to be thrown out from under the mower resulting in possible injury and/or
property damage. Ground contact also produces a severe shock load on the mower drive and to the mower
blades resulting in possible damage and premature wear.