Filter
Top Products
OPERATION
OPERATION
Operation Section 4-35
© 2004 Alamo Group Inc.
SR10M/SR15M 10-01
12. MOWER STORAGE
Properly preparing and storing the mower at the end of the season is critical to maintaining its appearance
and to help ensure years of dependable service. The following are suggested storage procedures:
It is critical that driveline clutches slip when an obstacle or heavy load is encountered to avoid mower and/
or tractor damage. If the mower sits outside for an extended period of time or is exposed to rain and/or
humid air, the clutch lining plates must be inspected to ensure they are not frozen together from rust or
corrosion. If the mower has been exposed to such conditions, at the start of each mowing season, and any
time it is suspected that the slip clutch plates may be frozen together, readjust the slip clutch as detailed
in Seasonal Clutch Maintenance of the maintenance section in this manual.
1. Thoroughly clean all debris off the mower to
prevent damage from rotting grass and standing
water.
2. Lubricate all mower grease points and fill gearbox
oil levels as detailed in the maintenance section.
3. Tighten all bolts and pins to the recommended
torque.
4. Check the mower for worn and damaged parts.
Perform repairs and make replacements
immediately so that the mower will be ready for
use at the start of the next season.
5. Store the mower in a clean, dry place with the
mower housing resting securely on blocks or at
ground level.
6. Keep the driveline yoke from sitting in water, dirt
and other contaminants.
7. Use spray touch-up enamel where necessary to
prevent rust and maintain the appearance of the
mower.
DANGER!
Never allow children to play on or around the Tractor and Implement. Children can slip or fall
off the Equipment and be injured or killed. Children can cause the Implement to shift or fall
crushing themselves and others. (SG-25)
It is recommended that the mower be stored with the center section and both wings fully lowered to ground level.
If the mower is stored with the wings in the raised position, select a level area and install wing transport braces
to prevent the wings from falling BEFORE disconnecting the mower hitch from the tractor.