Filter
Top Products
MAINTENANCE
Maintenance Section 5-2
© 2004 Alamo Group Inc.
SR10M/SR15M 10-01
MAINTENANCE
Before operating your Rotary Cutter, make sure it is properly lubricated and thoroughly inspected. Only a
minimum of time and effort is required to regularly lubricate and maintain this machine to provide long life and
trouble free operation.
WARNING Always disengage the PTO before raising the Rotary Cutter for transporting or making
adjustments.
LUBRICATION INFORMATION
Do not let excess grease collect on or around parts, particularly when operating in sandy areas. The
accompanying illustration shows lubrication points. The chart gives the frequency of lubrication in hours, based
on normal operating conditions. Severe or unusual conditions may require more frequent lubrication. FIG. 1.
Use an SAE multi-purpose, lithium-type grease for all locations shown except location #2. On center and wing
gearbox use recommended lubricant on following page. Be sure to clean the fitting thoroughly before using
grease gun. Daily lubrication of the wing driveline slip joint is necessary. Failure to maintain proper lubrication
will result in damage to U-joints, gearbox, and/or driveshaft. FIGURE 1.
WHEEL HUB ASSEMBLY
The Wheel Hub Assemblies need to be lubricated on a weekly
basis.
Grease
Weekly
Lubrication Fitting Location
ITEM Description Frequency
1 U-Joints 8 Hours
2 Gearbox Check daily
3 Divider Gearbox Check daily
4 Axle Adjustment Rod 8 Hours
5 Tongue Pivot 8 Hours
6 Wheel Hubs Weekly
7 Telescoping Members 8 Hours
6
2
4
2
1
2
1
3
5
7
1