Filter
Top Products
ASSEMBLY
Assembly Section 3-2
© 2004 Alamo Group Inc.
SR10M/SR15M 10-01
ASSEMBLY
Set up mower as received from factory with these instructions. Refer to Parts Listing Section for further
information when necessary.
Select a suitable working area. Open parts box and lay out parts to make location easy. Refer to parts listing
and exploded view drawings in the Parts Listing Section and the packing list.
Cut all wire ties, including those on blades if present.
This mower is shipped partially assembled. Assembly will be easier if components are aligned and loosely
assembled before tightening hardware. Refer to Torque Chart when tightening hardware.
Position Center Section on a flat surface. Elevate approximately 10 inches from ground to permit the installation
of Wing Sections.
BLADE CARRIER AND BLADES
The Frame sections are shipped from the factory without the Blades attached to the Blade Carrier. Optional
Straight or Fan Blades are available.
WARNING Do not install Blades or do any work under the Cutter sections unless the section(s) are
safely and securely blocked or latched in place.
The Blade Bolts must be tightened to 250 ft. lbs. torque before operating. NOTE: Blade Bolts have left-hand
threads.
To insure proper installation, check to see that Blade cutting surfaces are correct for counterclockwise rotation
on the Center Section and on the Right Wing Blade Carrier. FIGURE 1. (Clockwise on Left Wing)
FIGURE 1
FIGURE 1
Blade Carrier
Left Wing Shown
NOTE: Cutting Edge
for Clockwise Rotation