Servis-Rhino SR15M Brush Cutter User Manual


 
OPERATION
Operation Section 4-30
OPERATION
© 2004 Alamo Group Inc.
SR10M/SR15M 10-01
10.5 Operating the Mower
Avoid mowing in reverse direction when possible. Check to make sure there are no persons
behind the Mower and use extreme care when mowing in reverse. Mow only at a slow
ground speed where you can safely operate and control the Tractor and Mower. Never
mow an area in the reverse direction that you have not inspected and removed debris or
foreign material. (SGM-8)
DANGER!
Only operate the mower from the tractor operator’s seat with the seatbelt securely fastened. The tractor must be
equipped with a ROPS in the raised position or a ROPS cab.
The mower is designed to cut vegetation up to 3” in diameter. Sharp blades will produce a cleaner cut and
require less power. Travel at a speed that allows the mower sufficient time to cut through the vegetation and
maintain the PTO operating speed to prevent overloading the mower and tractor. Choose a driving pattern that
provides the maximum pass length and minimizes turning.
Under certain conditions, tractor tires may roll some grasses down preventing them from being cut at the same
height as the surrounding area. When this occurs, check to ensure that the tractor tires are spaced at least 60”
apart measured from inside to inside of tires. Lower cutting heights in general will also increase cutting
performance. Reducing the tractor ground speed while maintaining the operating speed of the mower may
permit downed grasses to at least partially rebound and be cut. Taking a partial cut and/or reversing the
direction of travel may also help produce a cleaner cut.
Avoid mowing in the reverse direction when possible. In situations where the mower must be backed to access
areas to be cut, make sure there are no persons or other foreign debris behind the mower before mowing in
reverse. When mowing in reverse, operate the tractor and mower at a reduced ground speed to ensure tractor
and mower control is maintained.
WARNING!
Do not mow with two machines in the same area except with Cab tractors with the windows
closed. (SGM-11)
Follow these guidelines to reduce the risk of equipment and grass
fires while operating, servicing, and repairing the Mower and Tractor:
-Equip the Tractor with a fire extinguisher in an accessible location.
-Do Not operate the Mower on a Tractor with an underframe exhaust.
-Do Not smoke or have an open flame near the Mower and Tractor.
-Do Not drive into burning debris or freshly burnt areas.
-Ensure slip clutches are properly adjusted to prevent excessive
slippage and plate heating.
-Never allow clippings or debris to collect near drivelines, slip
clutches, and gearboxes. Periodically shut down the Tractor and
Mower and clean clippings and collected debris from the mower
deck. (SGM-12)
WARNING!