Filter
Top Products
ASSEMBLY
Assembly Section 3-13
© 2004 Alamo Group Inc.
SR10M/SR15M 10-01
ASSEMBLY
WINCH ASSEMBLY ATTACHMENT (OPTIONAL EQUIPMENT)
Attach the Winch Stand to the cross bar on the Center Section with bolts and locknuts. Attach the Winch to the
Winch Stand with bolts and locknuts. See Operation Section for use.
THREE SPOOL CONTROL VALVE INSTALLATION
A Three-Spool Control Valve is available from your dealer for use with tractors having either an open or closed
center Hydraulic System. If a 3 spool valve bank is required assemble on bracket and install on tractor fender at
desired location. Refer to Parts List Section. To install the hydraulics from the Mower to the Control Valve,
connect the Center Axle Lift Cylinder Hose to the Right Port on the Hydraulic Valve. Connect the Wing Folding
Cylinder Hoses to the same side of the Control Valve as the Cylinder are on the Mower rather than crossing the
Hoses. Route hoses through front and rear hose brackets. Remove plastic plug from Breather of Cylinder
before operation.
3-Spool Control Valve
(540 RPM 1-3/8"-6)
(1000 RPM 1-3/8"-21)