Filter
Top Products
ASSEMBLY
Assembly Section 3-9
© 2004 Alamo Group Inc.
SR10M/SR15M 10-01
ASSEMBLY
WING SECTION HYDRAULIC CYLINDER ATTACHMENT
Mount the 14" stroke Hydraulic Cylinder butt clevis to the upright lugs on the Center Section and the rod end to
lugs on wing. Make sure the ports of the Hydraulic Cylinder are facing upwards. Keep the ports capped until the
hoses are attached to the tractor and are ready to attach to the cylinder ports. FIGURE 12. Install the Transport
Bars to retain the Wing Sections in the upright position for transport on roads and highways. When in transport
keep the Center Section as low to the ground as possible to increase stability but high enough to prevent the
Skid Shoes from dragging.
FIGURE 12. Wing Section Hydraulic Cylinder Attachment.
Transport Bar-
Operating Position
COUNTERWEIGHT BOX ATTACHMENT ON TWO SECTION UNITS
Keep everyone clear when lifting, and working under raised components. Block securely before working
under mower. Install Weight Box and Weight (Minimum of 700# Total) before operating to prevent turning
over the center section which can cause SERIOUS BODILY INJURY or DEATH. Without weight. Do not fold
wing. Attach transport strap securely to prevent inadvertent dropping from the transport position and possible
CRUSHING INJURY or DEATH.
Wing Hydraulic
Cylinder