Filter
Top Products
ASSEMBLY
Assembly Section 3-12
© 2004 Alamo Group Inc.
SR10M/SR15M 10-01
ASSEMBLY
DRIVELINE CLAMP CONE YOKE OPERATING
INSTRUCTIONS
Loosen the yoke clamp cone with a 11/16” (17mm) wrench and
remove the cone from yoke. Slide yoke onto the shaft and
align hole for clamping cone with annular groove of gearbox
shaft. Reinstall cone and tighten (75 lb-ft torque). Push and pull
the driveline to ensure it is securely attached to the shaft.
Regularly check the driveline yoke to ensure a tight connection.
To remove the yoke, remove the connecting cone and pull yoke
off the shaft. If the cone cannot be easily removed by hand,
drive it out from the other side using a hammer and punch.
NOTE: The clamping cone is serviced only as a complete
assembly. Do not attempt to disassemble the clamping cone.
Clamping Cone
Driveline Yoke
11/16" Bolt End
EQUAL ANGLE JACKSHAFT DRIVELINE
Attach bearingsupport weldment (ref #1) to torque weldment as shown. Install jackshaft bearing (ref #2) onto
jackshaft stub end.
1
2
4
6,7
13
11
8,9
5
3
10
12
MOUNT IN THIS HOLE FOR 1000
MOUNT IN THIS HOLE FOR 540
R 12-06-01