Filter
Top Products
OPERATION
Operation Section 4-16
OPERATION
© 2004 Alamo Group Inc.
SR10M/SR15M 10-01
“Bottoming Out” Check Procedure
1. Disconnect driveline from the tractor and slide the
profiles together until fully compressed.
2. Place a mark on the inner shield 1/8” from the
end of the outer shield and reattach the driveline
to the PTO shaft.
3. With the PTO NOT TURNING, slowly drive the
tractor with mower attached through the sharpest
turn possible and watch shaft movement. With
the PTO NOT TURNING, slowly drive the tractor
with the mower attached through the most severe
terrain conditions expected and watch shaft
movement.
4. If the distance between the mark and the outer
shield becomes less than 2” at any point there is
a potential problem bottoming out the driveline and
the driveline should be shortened.
Driveline in maximum compressed position.
Engagement Check Procedure
1. With the driveline attached, position the mower to the point where the telescoping driveline is at its maximum
extension. Completely shut down the tractor and secure in position.
2. Mark the inner driveline shield 1/8” from the end of the outer shield.
3. Disconnect the driveline from the tractor and separate the two driveline halves.
4. Measure the distance from the mark to the end of the inner profile. This length is the amount the driveline
profiles were engaged.
5. If the engaged length is less than 12” for a CV driveline and less than 6” for a non-CV driveline, the shaft is
considered too short and should be replaced with a longer shaft. Consult an authorized dealer to purchase
the required driveline length.
NOTE: If the driveline cannot be shortened and still maintain the required profile engagement, the operator
must be made aware of terrain conditions and avoid situations which pose a potential problem to avoid damaging
the driveline.
Shorten the driveline profiles as follows:
1. Remove the driveline from the tractor.
2. Position the mower to the point with the shortest
distance between the tractor PTO shaft and cutter
gearbox. Shut down the tractor and securely
block the mower in this position.
3. Pull driveline apart and reattach yoke to PTO
shaft.
4. Hold driveline sections parallel to one another and
measure back 1” from yoke of each shaft and
place mark on opposite section. Cut this length
off with a saw.
5. Round off all sharp edges and debur.
6. Thoroughly grease then reinstall the driveline.
7. Recheck for proper operation.