Filter
Top Products
MAINTENANCE
Maintenance Section 5-4
© 2004 Alamo Group Inc.
SR10M/SR15M 10-01
MAINTENANCE
DIVIDER GEARBOX
The Test Plug for the Divider Gearbox is located on the right side of the input shaft. The filler pressure relief Plug
is on top of the Gearbox. FIGURE 4.
FIGURE 6
GREASE EVERY
8 HOURS
Recommended lubricant for Gearbox is NLGI
000 Grease (P/N 00765444) with a 3-1/2 quart
capacity.
DRIVELINES
The Drivelines and U-Joints should be inspected each morning before the mower is started. FIGURE 5 & 6.
The U-Joint and CV Joint on the Driveline undergo extreme forces when the unit is turning or when the Wings
are being raised. It is important that the U-Joints and CV Joint be greased each day before the unit is started. The
U-Joints are located at each end of the Center and Wing Drivelines. The CV Joint is located at the end of the Main
Driveline. The U-Joint and CV Joint assemblies are accessible by rotating the Driveline Safety Shield until the hole
in the Shield matches up with the Grease Fitting. Use #2 Bearing Grease for lubrication. Inspect the U-Joint for
wear by holding the shaft on one side of the U-Joint while trying to rotate the shaft on the other side of the U-Joint.
If there is noticeable movement in the Driveline replace the U-joint before it causes severe damage to the Driveline.
GREASE EVERY
8 HOURS
Do not over-fill. If gearboxes are
filled above the Test Plug Level,
Pressure under working conditions
may cause grease seals to leak.
Filler Pressure
Relief Plug
Test Plug
CAUTION