Filter
Top Products
MAINTENANCE
Maintenance Section 5-6
© 2004 Alamo Group Inc.
SR10M/SR15M 10-01
MAINTENANCE
MAIN DRIVELINE & CAT 4 SAFETY SHIELD
To remove the main inner driveline shield, Remove the locking screws. Align the bearing tabs with the cone
pockets. FIGURE 15. Remove the half-guard and remove the bearing ring. FIGURE 16.
FIGURE 15
FIGURE 16
Inspect the driveline shield for worn areas or cracks. If the shield has any dents or cracks, replace the Shield.
While the Shields are off, examine the Driveline for signs of abnormal wear, bent or twisted shafts, or cracks in
the shafts or tubes. Check to see that the Drivelines telescope easily. If the Drivelines do not telescope properly
or show signs of abnormal wear, the shaft should be repaired or replaced.
To assemble the main inner driveline shield, grease the yoke groove and inner profile tube. Attach the
bearing ring in groove with recesses facing profile tube. FIGURE 17. Slide on the half shield. Turn the cone
until it engages correctly. Install locking screws. FIGURE 18.
FIGURE 17
FIGURE 18