Filter
Top Products
88 Adding Parts
www.dell.com | support.dell.com
4 Unpack the drive and prepare it for installation.
See the documentation that came with the drive to ensure that the
drive is setup for your computer.
5 Open the computer cover (see page 67).
6 To remove the front panel insert, carefully press the panel out from the
inside of the computer.
7 To remove the drive-bay cover panel, press the four tabs and pull the
insert away from the panel.
8 Remove the two short, green plastic rails from the inside of the drive
cage.
These rails are not attached to the drive cage with screws. To remove
the rails, firmly pull the rails from the drive cage.
9 Attach the rails to the drive using the two captive screws on each rail.
Ensure that the rail tabs are positioned at the back of the drive.
10 Gently slide the drive into the bay until you hear a click.
securing tabs (4)
drive-bay cover panel
front panel insert
securing tab
remove front panel
insert through here
front panel insert
9p915bk0.book Page 88 Thursday, April 4, 2002 9:26 AM