Filter
Top Products
100 Appendix
www.dell.com | support.dell.com
CAUTION: A new battery can explode if it is incorrectly installed.
Replace the 3-V CR2032 battery only with the same or equivalent
type recommended by the manufacturer. Discard used batteries
according to the manufacturer’s instructions.
1
Record all the screens in the system setup program so that you can
restore the correct settings in step 7.
2 Open the computer cover (see page 67).
3 Locate the battery socket BATTERY (see page 70).
4 Remove the battery by carefully prying it out of its socket with your
fingers or with a blunt, nonconducting object such as a plastic
screwdriver.
NOTICE: To avoid damage to the system board while you pry the battery
loose, be sure to insert the plastic screwdriver between the battery and the
socket (not the system board).
5
Insert the new battery into the socket with the side labeled “+” facing
up and snap it into place.
6 Close the computer cover (see page 90), and plug your computer and
devices into their electrical outlets.
7 Access the system setup program (see page 97) and restore the settings
you recorded in step 1.
8 Properly dispose of the old battery (see page 99).
battery socket
(BATTERY)
battery
9p915bk0.book Page 100 Thursday, April 4, 2002 9:26 AM