Filter
Top Products
Adding Parts 73
8 Lower the plastic securing lever.
9 Connect any cables that should be attached to the card.
See the documentation that came with the card for information about
the card cable connections.
10 Close the computer cover (see page 90).
11 Connect your computer and devices to their electrical outlets, and
turn them on.
NOTICE: To connect a network cable, first plug the cable in to the network
wall jack and then plug it in to the computer.
12
Install any drivers required for the card as described in the
documentation that came with the card.
Removing Cards
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions listed in "When Working Inside Your
Computer" on page 12.
1
Shut down the computer (see page 20).
2 Turn off any attached devices and disconnect them from their
electrical outlets.
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network wall jack.
3
Disconnect the computer power cable from the wall outlet, and then
press the power button to ground the system board.
4 Open the computer cover (see page 67).
5 If necessary, disconnect any cables connected to the card.
6 To raise the securing lever, press the tab until it is free from the latch
and then lift the lever.
9p915bk0.book Page 73 Thursday, April 4, 2002 9:26 AM