Filter
Top Products
Adding Parts 87
10 Connect a power cable to the drive.
11 See the documentation that came with the drive for instructions on
connecting a drive cable to the drive and system board.
HINT: Your computer
uses cable-select drive
cables. This means that
the device connected to
the end connector of the
drive cable is the master
device and the device
connected to the middle
connector is the slave
device. Be sure the jumper
setting on the new device
is set for "cable select"
(see the documentation
that came with the drive
for information).
12
Connect your computer and devices to their electrical outlets, and
turn them on.
NOTICE: To connect a network cable, first plug the cable in to the network
wall jack and then plug it in to the computer.
13
See the documentation that came with the drive for instructions on
installing any software required for drive operation.
3.5-Inch Devices
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions listed in "When Working Inside Your
Computer" on page 12.
1
Shut down the computer (see page 20).
2 Turn off any attached devices and disconnect them from their
electrical outlets.
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network wall jack.
3
Disconnect the computer power cable from the wall outlet, and then
press the power button to ground the system board.
power cable
drive cable
9p915bk0.book Page 87 Thursday, April 4, 2002 9:26 AM