Filter
Top Products
80 Adding Parts
www.dell.com | support.dell.com
11 Right-click the My Computer icon and then click Properties.
12 Click the General tab.
13 To verify that the memory is installed correctly, check the amount of
memory (RAM) listed.
Replacing the AGP Card
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions listed in "When Working Inside Your
Computer" on page 12.
1
Shut down the computer (see page 20).
2 Turn off any attached devices and disconnect them from their
electrical outlets.
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network wall jack.
3
Disconnect the computer power cable from the wall outlet, and then
press the power button to ground the system board.
4 Open the computer cover (see page 67).
5 Press the card clip lever on the side of the AGP card to release the card
from the slot connector, and remove the card.
6 To replace the AGP card, gently press it down into the slot connector
until it clicks into place. Press the card clip lever while inserting the
card into the slot connector.
card clip
lever
AGP card
AGP card clip
slot connector
back of computer
9p915bk0.book Page 80 Thursday, April 4, 2002 9:26 AM