Filter
Top Products
6.0 Tower and Wind Turbine Generator Installation
NOTICE: Use of the material contained in this document is subject to the warning on page Iv and the disclaimer
on page v of this document.
DOC012R02 AOC 15/50 User Manual Nov 2001
42
DO NOT SUBSTITUTE BOLTS. Only the AOC supplied Grade 8, fine thread bolts, 5/8" x
3", should be used to secure the blades to the hub. The tip brakes can be unlatched or
removed (if necessary) to prevent damage during the mounting process.
The four corner bolts on the blade should be installed, initially without the washers, to hold the
blade in place. The pitch tool should be inserted first, in slot #1 (see Figure 6.10), and secured
with a bolt inserted snug tight.
Figure 6-4 Yaw lock on tower top
Yaw Lock
Bottom View
Lock
Unlock