Filter
Top Products
© 2006 Alamo Industrial
Section 9 - 10
Axtreme Boom (Asy Man) 07/06
5. Terminal Connections. The Valve is
mounted on the left hand side of the hydraulic
tank.
PLUG FUNCTION
1 1 st Plug Swing Terminal
2 2 nd Plug Lift Terminal
3 3 rd Plug Dipper Terminal
4 4 th Plug Tilt Terminal
5 5 th Plug Door Terminal
Always check to make certain that the plugs are
securly mounted t mthe valve.
6. Wire Harness Completed. Pull the Wire
harness back toward Cab to remove any ex-
cess slack, only enough to remove slack not to
make Wire Harness tight. Tie wire harness or
hoses to Tractor Frame Rails to prevent them
from rubbing or getting caught on something.
The Wiring Schematic is shown in this book as
a reference only, the wire harness will come to
you assembled and ready to mount. The only
wires that will have to be altered are the wires
inside that connect to the existing Tractor Wires.
These inside wires are intentionally left long so
they can be cut as needed. None of the wires
with the factory plugs will have to be cut.
FIGURE 24
Short Handle
Phillips
Screwdriver
Installing Wire Harness To Valve:
(Continued)
Swing
Lift
Dipper
Tilt
Door
FIGURE 23
Joystick Mounting
FIGURE 22