Filter
Top Products
© 2006 Alamo Group Inc.
Section 11 - 2
Axtreme Boom (Asy. Manl) 07/06
PRE-DELIVERY INSPECTION CHECKLIST
Pre-Operation Inspection: Check the following items before operating the unit to assure
that they are properly assembled. (See previous pages for component location)
Saftey Equipment:
----- Operators Manual is with Unit.
----- The Safety Decals are installed as listed in the Assembly Manual.
----- Valve operation plate is installed.
----- Operators cage or Tractor Cab is in place.
----- Deflectors are installed on the Mower Head.
----- Tractor Rops or Cab with seatbels installed properly.
Frame and Boom:
----- Axle Plate Bolts are torqued.
----- Boom Rest Axle Plate Bolts are torqued.
----- Front Rail Bolts are torqued .
----- Front Support Bolts at tractor are torqued.
----- Rear Rail Bolts torque .
----- Rotator bolts torque to.
----- All Welds inspected toinsure proper welds and locations.
Hydraulic System:
----- Oil Level in Hydraulic Tank is within the sight gauge.
----- Hose connections are tight.
----- Hoses do not have any kinks or twist in them.
----- Front Pump Shaft adapter bolts are tight..
----- Front Pump Shaft Coupler / Drive Shaft is lubricated and has an anti-seize compound
on the Splines of Pump and Shafts.
----- The Pump Drive Shaft has correct alignment.
----- Suction Hose has no leaks or kinks.
Rotary Mower Head:
----- Skid Shoe Bolts are torqued to 120 ft. lbs.
----- Spindle Housing Bolts are torqued to 400 ft. lbs.
----- The Spindle Housing is properly lubricated.
----- Motor Bolts are torqued to 120 ft. lbs.
----- Blade Carrier (Bar) Bolts torque to 400 ft. lbs.
----- Blade Bolts are torqued and the retainings Pins are in place.
----- Blades Swing freely.
Boom:
----- All Hoses tightened and no leaks.
----- All hoses secured to where they will not rub, get pinched or hanging down where they may
catch on something.
----- All Decals installed
----- Pump Primed and Pressure adjusted if needed (only applys to Pump for Cylinder control.