Filter
Top Products
Axtreme Boom (Asy Man) 07/06
© 2006 Alamo Industrial
Section 8- 8
Figure 11
Valve Remote Cable Controls
13. The Arm Rest is bolted to the Control
Handles. This has some options as to where it is
bolted and can be bent to adjust to individual
preference. (See Figure 11).
14. Control Handle Stand is bolted to the floor
of the Cab under the Floor Mat on the right hand
side oir to the cab support post with a fabricated
bracket.
. There is a rubber plug in floor under floor mat
here. Remove and/or cut the rubber plug to run the
cables and wire harness through it. The opening around
cables through rubber plug can be sealed using silicone
sealer. Floor mat will lay back down around cables and
leave a small area of floor mat opening. (See Figure 11)
Figure 12
15. Cable Handle Control Instructional Decal. There will be a decal showing the operation of the spools
of the valve that will show you how the handles shoud be placed.
Figure 13
13. Control Handle Adjusted to neutral position.
Adjust the cable control handle to the neutral posi-
tion. Using the two locking nuts on the cable hous-
ing to adjust the handle to the neutral position.
Loosen one nut and tighten the other the cable can
be moved back and forth in the valve mounting
bracket. This must be done before operating the
mover.