Filter
Top Products
© 2006 Alamo Industrial
Section 9 - 8
Axtreme Boom (Asy Man) 07/06
Joystick Mounting
Cut Tractor Starter
Wire to Starter Sole-
noid and reroute
through Joystick
Harness Brown
wires.
Shown here is typical Ignition
connection, Your Ignition may
vary but the function will not.
Tractor
Ignition Switch
Ignition
FIGURE 17
From
Battery
ACC Wire
Starter
"S"
Starter "S"
terminal
Interupt
Starter "S"
terminal
Interupt
To Tractor
Starter "S"
terminal
Tractor Ignition Terminal
Tractor Ignition
Supply to Joystick
To Tractor Battery
12VDC (+ Pos)
To Tractor Battery
12VDC (- Neg.)
Joystick Wiring
Harness
7. Connecting Harness Wires. There are 5 wires that must be connected to Tractor wiring, these
wires will be marked with the description of what they are from the factory.
1. Power supply to joystick, this wire will be connected to the tractors ignition switch wire,
as close to the ignition switch as possible. It is recommended to be not more that 3"
away from ignition switch.
2. This is the tractor starter interrupt switch. It connects to the wire to the tractors starter
solenoid marked "S", this prevents the tractor from being started when the mower is in
the on position.
3. This is the return for the tractor starter interrupt switch. It is connect back into the other
end of the cut starter solenoid wire.
4. Battery 12 VDC + connection which connects direct to the battery terminal. This wire
will power a relay that will operate the electric cooling fan for the hydraulic oil.
5. Ground wire, This connect direct to the negative Battery terminal of the battery. It will
serve as a ground for the system.
8. Reinstall Dash Panel. Reinstall any dash panels after the wires have been connected to the
tractors wiring system if they were removed . Dash panels will vary with the type and model tractor
used, the type fasteners will vary. Consult tractors manufacturer service repair and/or parts manual
for removing any fasteners fro the tractor components. Note: All wires for the tractor connection with
wire harness should all be under floor mat of tractor and not visible with the exception of the harness
running up to the bottom of the joystick this will prevent damage to the wiring. (See Figure 18 & 19)
1
5
4
3
2