Filter
Top Products
© 2006 Alamo Group Inc.
Section 3 - 6
Axtreme Boom (Asy. Man) 07/06
Lay Out Components in Display. It is helpful to lay out the component in as neat a display
as possible. Lay out the Bolts according to size and length. Lay out the Nuts and washer by size. This
will allow you to see how many of each part as you use them and help to identify any missing parts. (See
figure 6) See Mount Kit Specification and Component Identification Section to help ID Components.
All the component that are received should be check and sorted as to what they are.
Shown below is a general example of the components laid out, this is not a lay out of
the components in this mount kit.
Tractor, Area Cleanliness
The Tractor, all tools and work area must be clean of dirt and debris when assembling any hydraulic
components. DO NOT leave any hydraulic component open to the elements. DO not use any containers
for fluids that are not clean and free of any other liquids. DO NOT use rags/cloth that has lint or fuzz on
them when working on hydraulic components. Keep all hoses capped until you are ready to connect
them.
Cleaning Boom and mower componets (electronics)
The units Components are designed to be water resistant. But the sealing can be damaged by Pressure
Washers, Steam Cleaners, Solvents or any other harsh chemical that would be used to clean the units
components. It is important to keep all electrical connections and components sealed and dry. When
washing and cleaning this unit it should be done with a non corrosive soap and low pressure spray of
water. It is recommended that all exposed electronic components be covered and protected from excess
moisture.
General Information / Installation Requirements