Filter
Top Products
Computer Communications with the PV225S
152607 2–33
GUI Configuration - Adding Inverters
Once the GUI has started, you will need to configure each Inverter icon to reflect
the appropriate operational parameters for each inverter that is connected to the
system. The software automatically defaults to one inverter. To program that
inverter accordingly, follow the directions provided below.
To configure the inverters in the GUI:
1. With the GUI Main Menu open, Right-click on the “Inverter 1” icon.
2. Click on the tabs to display each page and fill out the required information.
3. Fill out the Detail Information in the form shown in Figure 2-19.
4. Fill out the Contact Information in the form shown in Figure 2-20.
Figure 2-19
Detail Screen
Fill out all the required
information on this
form.
Form Tab
Figure 2-20
Contact Screen
Fill out all the required
information on this
form.
Form Tab