Filter
Top Products
Operator Interface
152607 2–21
Setting the Date and Time
Follow the procedure below to change the date and time.
To change the Date and Time:
1. From the standard display, press the <M
ENU> key. This will prompt the user
for the password. The LCD will change the third and fourth lines of the LCD
display as follows:
“
Type and
Hit ENTER
”
“
Password:
”.
2. Enter the password <5><9><4> and press the <E
NTER> button.
3. Scroll down with the \/ key until date or time parameters are reached.
a) If you’re changing the date, the third and fourth lines of the LCD will
display as follows:
“
Type and hit ENTER
”
“
Set Date: MMDDYY
”
b) If you’re changing the time, the third and fourth lines of the LCD will
display as follows:
“
Type and hit ENTER
”
“
Set Time: HHMMSS
”
4. Press <E
NTER>. Enter the proper date or time in a six digit format. For
example:
a) The date is entered month-day-year (mmddyy):
April 28, 2005 is entered
042805
<ENTER>.
b) The time is entered in military hours-minutes-seconds
(i.e., 24-hour clock): 4:30 pm is entered
163000
<ENTER>.
If a mistake is made while entering the date or time, the /\ and \/ keys may be
used as a backspace key. Any two-digit year “YY” may be entered for the
date, but regardless of the keyed entry, the maximum Month/Day “MMDD”
that the UFCU will accept is a “1231” or Dec. 31st. The maximum allowable
time entry the UFCU will accept is “235959”.
5. Once the entry is accepted, the third and fourth lines of the LCD display will
revert back to the following:
a) If you’re changing the date, the third and fourth lines of the LCD will
display as follows:
“
Hit ENTER to set
”
“
Set Date:
”
b) If you’re changing the time, the third and fourth lines of the LCD will
display as follows:
“
Hit ENTER to set
”
“
Set Time:
”
6. Pressing the <M
ENU> key will return the user to the standard display.