Support User Manuals

Toshiba VF-nC1 Portable Generator User Manual

Open as PDF

of 143

E6581090

D-10

4

4.1.5 Parameters that cannot be changed while running

For reasons of safety, the following parameters have been set up so that they cannot be

reprogrammed while the inverter is running.

[Basic parameters]

EOQF(Command mode selection)

HOQF(Frequency setting mode selection)

V[R (Standard setting mode selection)

HJ (Maximum frequency (Hz))

XN (Base frequency 1 (Hz))

RV (V/f control mode selection)

[Extended parameters]

H(Analog input/logic input function

selection)

H(Always active function selection (ST))

H(Input terminal selection 1 (F))

H(Input terminal selection 2 (R))

H(Input terminal selection 3 (S1))

H(Input terminal selection 4 (S2))

H(Input terminal selection 5 (VI/S3))

H(Sink/Source selection)

H(Output terminal selection 1 (OUT/FM))

H(Output terminal selection 3 (FL))

H (Base frequency 2 (Hz))

H (Base frequency voltage 2 (V))

H (DC braking current (%))

H (PWM carrier frequency)

H (Auto-restart control selection)

H (Regenerative power ride-though

control)

H (Over voltage limit operation)

H (Slip frequency gain)

H (Base frequency voltage 1 (V))

H (Motor rated current)

H (Motor no-load current)

H (Motor rated speed)

H (Speed control gain)

H (Speed control stable coefficient)

H (Stall prevention level)

H (External input trip stop mode

selection)

H (Input phase failure detection

mode selection)

H (Under voltage trip selection)

Set H, and EOQF and HOQF can be changed

while the inverter is runnin

g

.

previous next