Toshiba VF-nC1 Portable Generator User Manual


 
E6581090
H-3
8
8.2 Display of trip information
If the inverter trips, an error code is displayed to suggest the cause. In the status monitor mode, all
trip records are retained.
Display of trip information
Error code Communication No. Description
PGTT (*) 0000 No error
QE 0001
Overcurrent during acceleration
QE
0002 Overcurrent during deceleration
QE
0003 Overcurrent during operation
QEN
0004 Load-side overcurrent during start-up
QEC
0005 Armature-side overcurrent during start-up
GRJ
0008 Input phase failure
GRJQ
0009 Output phase failure
QR
000A Overvoltage during acceleration
QR
000B Overvoltage during deceleration
QR
000C Overvoltage during constant-speed operation
QN
000D Inverter overload trip
QN
000E Motor overload trip
QJ
0010 Overheat trip
G
0011 Emergency stop
GGR
0012 E2PROM fault 1
GGR
0013 E2PROM fault 2
GGR
0014 E2PROM fault 3
GTT
0015 Inverter RAM fault
GTT
0016 Inverter ROM fault
GTT
0017 CPU fault trip
GTT
0018 Communication error
GTT
001A Current detector fault
WR
001E Undervoltage trip
GH
0022 Ground fault
QER
0025 Overcurrent flowing in element during acceleration
QER
0026 Overcurrent flowing in element during deceleration
QER
0027 Overcurrent flowing in element during low-speed operation
G
0032 Trip caused by a break in an analog signal cable
G
0033 CPU communication error
G
0034 Excessive torque boosted
(Note) Past trip records (trip records retained or trips that occurred in the past) can be called up.
(Refer to 8.1 "Status monitor mode" for the call-up procedure.)
(*) Strictly speaking, this code is not an error code; this code is displayed to show the
absence of error when the past trip monitor mode is selected.