Filter
Top Products
Groundsmaster 4000--D/4010--DHydraulic System Page 4 -- 22
Mow Circuit Cutting Deck Blade Braking
Whenthe operator turns the PTOswitch OFFor ifadeck
is raised with the PTO switch ON, PTO manifold propor-
tional relief valve (PRV) is de--energized causing logic
valve (LC1) to shift (refer to information in Mow Circuit
in this section). This shifted cartridge directs oil return
out of manifold port P2. As circuit pressure decreases,
pilot direction valve PD is shifted to it’s neutral position,
preventing return flow from the deck motor and slows
the cutting blades (Fig. 12).
Theinertia ofthe rotating cuttingblades, however,effec-
tively turns the deck motor into a pump causing an in-
crease in pressure as the flow from the motor comes up
against the closed relief valve (RV). When this pressure
builds to approximately 600 PSI (41 bar), relief valve
(RV) opens which allows hydraulic flow to flow from the
motor (Fig. 13). When return pressure drops below 600
PSI (41 bar), relief valve (RV) reseats to once again
block return flow from the deck motor to further slow the
cuttingblades. Thisactionof thebrake reliefvalveopen-
ingoccurs severaltimesin averyshort timeframeas the
blades finally come to a stop. Once the blades have
stopped, relief valve (RV) remains seated t o keep the
deck motor from rotating.
Figure 12
P1
P2
M1
M2
LC1
PRV
PD
RV
3000PSI
CD
RIGHTDECK
1.17 CID
600PSI
.025
PUMP
RETURN
FLOW
RETURN
PRV NOT ENERGIZED
LC1 SHIFTED
PTO SWITCH OFF
G
Figure 13
P1
P2
M1
M2
LC1
PRV
PD
RV
3000PSI
CD
RIGHTDECK
1.17CID
600PSI
.025
PUMP
RETURN
FLOW
RETURN
PRV NOT ENERGIZED
LC1 AND RV SHIFTED
PTO SWITCH OFF
G